Distribution-Grip Dead-End, is a helical termination primarily for bare aluminum based right-hand-lay conductors. It provides the required holding strength in standard “Distribution” construction and permits for the continuation of the conductor through the termination without damage and without having to cut and splice it.  Covers conductors from 0.182” to over 1.2” in diameter. This termination is not for use in OHSW.”

  • Tools are not required nor recommended to install Distribution-Grip Dead-Ends, except for hot stick applications.
  • Designed to grip the conductor uniformly to prevent distortion of the conductor.
  • Unique design that eliminates bolts, nuts, washers and other component parts that may become lost or damaged during installation or in service.

 

 

Application Procedures

SP-2071 (Distribution-Grip Dead-End)

 

Catalog Pages

Distribution-Grip Dead-End - Catalog

Distribution Grip Dead end

 

LARGE SIZES

Distribution Grip Dead end1

 

For use on: AWAC®, Aluminum/Aluminum-Clad Steel

Distribution Grip Dead end2

 

For use on: Plastic Jacketed Conductors, Polyethylene, Neoprene, Vinyl, Rubber

Distribution Grip Dead end3