The PLP Tie Top Polymer Insulators are designed to match the head, neck and mounting pin requirements of ANSI C29.5, Class 55-3, 55-4, 55-5, 55-6, and 55-7 as well as ANSI C29.6, Class  56-1 pin-type insulator standards. “C” (2 -1/4" nominal), “F” (2-7/8" nominal) and “J” (3-1/2") neck sizes are available. By using ANSI head and neck dimensional standards, PLP metal or plastic factory formed ties will install easily and provide superior holding and electrical performance on PLP Tie Top Polymer Insulators. Consult PLP for the suitability of other factory formed tie brands with these insulators. Covered or bare hand tie wire is also suitable for use with PLP Tie Top Polymer Insulators depending on conductor type.

  • Superior moisture and contamination shedding
  • UV stabilized material
  • Matched dielectric properties
  • High impact resistance
  • Lightweight design
  • ANSI 29.5 compliant
  • Dramatically reduces abrasion
  • Ideal for jumpers or stinger wires
  • Ideal for use with shot gun sticks
  • Manufactured from a proprietary high density polyethylene-based compound
  • Tie top designs are perfect for use with all PLP ties
  • Two (2) torque bolts included with each Vise Top insulator

Application Procedures

SP-3245 (Polymer Insulator Tie Top)

 

Catalog Pages

Polymer Insulators Tie Top - Catalog

Polymer Insulators - Catalog

 

Sales Materials

Polymer Insulators Tie Top - Sell Sheet

 

Reports & Manuals

Overhead Distribution Line Repair Manual

 


 Table PolyInsTieTop

Polymer Insulator Questions and Answers

 

Polymer Insulator Accessories